Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ What goes on this connection

Posted by: dt4 Jun 12 2020, 01:34 PM

Underneath the fuel tankAttached Image

Posted by: mepstein Jun 12 2020, 01:42 PM

Sorry. Read the op wrong.

Posted by: JOEPROPER Jun 12 2020, 01:42 PM

QUOTE(dt4 @ Jun 12 2020, 03:34 PM) *

Underneath the fuel tankAttached Image

The wire harness connects to the fuel sending unit and the drain tube goes thru the hole under the gas tank. The other 2 are a fuel line and an evap line.

Posted by: RoadGlue Jun 12 2020, 01:44 PM

Do you mean on the second fuel line? There's a lot going on in this photo, so it's hard to know what you're talking about.

The car has both a feed and return line for the fuel system, but if you car was swapped to carbs at some point, then the return line isn't used and may explain why it's disconnected.

The wire and connector hanging is the fuel level sender connection, which plugs in on the top of the tank.

Posted by: dt4 Jun 12 2020, 02:04 PM

QUOTE(RoadGlue @ Jun 12 2020, 08:44 PM) *

Do you mean on the second fuel line? There's a lot going on in this photo, so it's hard to know what you're talking about.

The car has both a feed and return line for the fuel system, but if you car was swapped to carbs at some point, then the return line isn't used and may explain why it's disconnected.

The wire and connector hanging is the fuel level sender connection, which plugs in on the top of the tank.

sorry, I realise now that I wasnt very clear
you have answered all the questions between you
The car is on carbs which explains why there isnt a pipe on the return

Posted by: DickSteinkamp Jun 12 2020, 06:36 PM

QUOTE(dt4 @ Jun 12 2020, 01:04 PM) *


The car is on carbs which explains why there isnt a pipe on the return


I think I'd be capping that return line.

Posted by: dt4 Jun 13 2020, 01:14 AM

QUOTE(DickSteinkamp @ Jun 13 2020, 01:36 AM) *

QUOTE(dt4 @ Jun 12 2020, 01:04 PM) *


The car is on carbs which explains why there isnt a pipe on the return


I think I'd be capping that return line.

easily done but why is it better to cap?

Posted by: dt4 Jun 13 2020, 12:38 PM

so I blocked it off but is wont run now so the tank will need to come back out to remove it to be sure that isnt the cause

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)