Hey all,
I have a '71, dual seats, no back rest. (carpeted firewall)
For any who have swapped to retractables in an early car where did you mount the receiver?
-Mounting near the head rest.... or floor?
-Weld a bung in and reinforcement plate?
-Drill through the fire wall, reinforce, nut on back?
-Make a sheet metal bracket....
Last question.. is there a trick to pulling these things out?
They retract well... other way around, not so much.
Here's a few quick/poor photos:
Happy Friday!
They have to be oriented properly to release.
Fixed belts are cooler.
I fitted retracts in my last early car (70). Was a long time ago and can’t remember the details but they worked just fine without any major mods. Seem to recall the bottom of the back pad bulging slightly
Currently using original non-retracts in current car. They are very difficult to adjust and cannot get them tight enough. Have no faith that they are effective.
Look cool - yeah but.....
Watching this as I plan to install retracts.
I gave up and put fixed 1970's back in, even though the cinnamon interior is out of 74 creamsicle
Attached thumbnail(s)
Hey guys,
Just a quick update. I read that 924 belts work well. 2 points and a bit more modern.
Since they are still REPA and branded in the same marquee it sounded like a good fit for me. (I am not too picky about originality)
For a set for $50 shipped on ebay and they already arrived.
Heres the fit:
After I test fit, I soaked everything in warm water and Dawn. Nice retraction and lock. Everything fits well when sitting in the seat. A decent option for anyone interested and not picky.
I love that you can plug and and play some parts within the brand.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)