Posted by: ri914 Sep 10 2020, 07:23 PM
Decided to clean up the 914 area a bit in prep for some major metal work this weekend. Came up with a nice collection of bits and pieces from the midway LS6 conversion.... Might be a nice garage picture for the future.
How many parts can you identify?
Posted by: SirAndy Sep 10 2020, 09:40 PM
QUOTE(IronHillRestorations @ Sep 10 2020, 06:35 PM)
all
I can also tell you that you have/had an early tail shifter car.
Posted by: Root_Werks Sep 11 2020, 10:09 AM
Took me a few minutes, but was able to place everything except the two sheet metal pieces. Dunno where on the 914 they go.
Posted by: 914e Sep 11 2020, 10:57 AM
QUOTE(Root_Werks @ Sep 11 2020, 09:09 AM)
Took me a few minutes, but was able to place everything except the two sheet metal pieces. Dunno where on the 914 they go.
I don't think the sheet metal scraps are from a 914, if they are, they got out of the factory before the rust was installed.
Posted by: fiacra Sep 11 2020, 11:08 AM
QUOTE(IronHillRestorations @ Sep 10 2020, 06:35 PM)
all
I recognize all the parts that Perry doesn't!
Posted by: bbrock Sep 11 2020, 12:43 PM
QUOTE(914e @ Sep 11 2020, 10:57 AM)
QUOTE(Root_Werks @ Sep 11 2020, 09:09 AM)
Took me a few minutes, but was able to place everything except the two sheet metal pieces. Dunno where on the 914 they go.
I don't think the sheet metal scraps are from a 914, if they are, they got out of the factory before the rust was installed.
The piece with the place turnbuckle "pad" from the fuel tank appears to be from the rear trunk floor.