Both the old and new adjustment screws have a recessed area behind the screw head. The HL assemble has to ears to accommodate the head.
Question is: How do I get the recessed portion betwee the ears ? On my pass side, I left the recessed part outside ears.
Top pic is the original screw; bottom pic is where I ended up...
@http://www.914world.com/bbs2/index.php?showuser=3348
Attached thumbnail(s)
Attached image(s)
I replaced my headlights from Sealed Beam to H4 units last week, so I did have to take that apart. I could 'click' them in with a little force.
Thanks. I’ll click them into place.
Sorry late to party,
Yes should pop in.
Yes.
The block slides into a receiver to hold it in place. The screws are best replaced in the ring while off. Not to say you can't, I just have done them in sets.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)