Hi, can anyone explain how to install rear sail trims? Having trouble with the roll bar clip lining up with the hole on the car. thanks
do you mean the horizontal piece or the side vertical piece?
for the side vertical piece it helps to have the bottom clip that is bolted down from underside , loosen that bolt by accessing the wheel well, helps to take the wheel off, as you slide it on the clip be careful not to scratch paint. as you get it forward enough as you get the top in line and slid over the end of the horizontal piece that should already be in place , the hole should line up but it may help to use a wire to find the hole and line it up before then getting the screw installed.
good luck, post some pictures too!
forgot to add—
Sorry. I thought meant vinyl. DRPHIL914 describes it.
Appreciate the advice. Its the vertical piece. The difficult is lining up the trim with the fixed piece that is bolts to the car. The piece seems to be smaller than the trim and moves around quite a bit. Might need to mask up the paint so i dont damage the paint. Will send through some pics as well before and after. Thanks again
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)