I've taken the engine/trans out of my car in my "get this six conversion back on the road after sitting for almost 20 years" quest, and since I'm in there, I'm replacing all the seals and whatnot that have obvious leakage issues going on.
Engine wise is pretty straight forward what's easy to do, and what requires something like splitting the case, so not too worried there. However, for the transmission, I'm not sure what I can do without making myself miserable.
I have the Erling gasket kit. And while the speedo, shift, input, and drive seals seem obvious, can I just take the case apart to replace the larger gaskets? The last thing I want to do is take everything apart to find out I need some sort of adjustment rig if I ever want it to go back together and shift correctly
I tried to find a writeup from someone either here or from the bird site that laid out all the steps, but I couldn't find anything about doing all the gaskets/seals in the kit. So if anyone has a link to one of those, that would be great.
Thanks all.
You didn’t mention which version of the tranny you would be working on. As for gaskets all can be replaced but the gaskets between the intermediate plate and the transaxle body must be replaced with the same thickness, this sets the pinion/ring gear backlash.
Most seals are pretty straight forward to replace.
The gasket kit at the Porsche dealer was under $20 when I first bought one, last time it was $130, 2 years ago.
you would be better off not to open the tranny
at least as far as the intermediate plate/gasket
I'd leave it alone unless you want to rebuild the inside
as mentioned, that gasket sets the ring and pinion differential
it MUST be the same as the original setting or will require a very special tool
I'd replace the front output, side outputs, etc.. and not open the box
you can take just the rear cover off and regasket that one, if you want...
the 2nd plate is the intermediate
Put the Magic Smoke back in by using Swepco gear oil!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)