Hope you guys and gals are all doing well!
Time to replace plug wires on my 1.7 D-Jet and was wondering on opinions of the group.
Some sets seem suspiciously cheap like $25
I came across these NGK wires that seemed priced more in line with good quality...
https://www.amazon.com/NGK-RC-VWC020-Spark-Plug-57403/dp/B0741PTNFD/ref=sr_1_1?dchild=1&keywords=57403+NGK&qid=1618362917&sr=8-1
input appreciated!
I did search through the forum but a lot of the threads were 10+ years old with some manufacturers NLA.
Sunny spring week up here in the PNW
Clewett.
Just bought a Clewett Engineering set. They are pretty darn nice. They have an extra nylon sheath over the silicone. Large numbered wires. Not sure if they are any better than a NGK set?
You can find that same exact set on Rock Auto for $20 cheaper. Decent quality for those dead presidents.
For Fuel injected I use the Bremi STI
Got them in stock
https://914rubber.com/spark-plug-wire-set-1
However if you have carbs the longer wire plugs will interfere with the intake manifolds. You need the Beru for that application. Yes we do have also .
Attached thumbnail(s)
Thanks all!
Have you thought about or know of a source that have pop-in plastic plug wire clips that are larger than stock for larger 7-8mm wires? I noticed the clips on the tins, but they are unusable.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)