Yes had the opportunity to make these ad very cost effectively. We are offering both the early and late front trunk springs finished in enamel just like factory (well kind of like factory).
What I mean by this is factory had them dipped and if you look closely there was a lot of excess paint. I think we did a better job. You be the judge.
We made the early at a 7.5" coil and the late at 8.375"
No that the factory only used one part number as they superseded them with the longer springs. From a manufacturing these I can tell you that the early has a higher tension load. This is probably why the late superseded it.
Will have these ready to ship in less than 2weeks (being finished now) , so who's in?
Attached thumbnail(s)
Im in for a set
Yep I'm in for a set. 75 late
What years are early and late?
I’m in for a set as well, but also don’t know when the early / late change occurred.
Thanks
Mack
Its my understanding that somewhere in 73 (I was thinking early 73) since they were superceded both will work.
I'm in for a set of late ones.
Early set for me please.
Getting a set out to Doug today.
Let us know what you think.
-Mark
1 set of early and 1 set of late please.
I will take a set!
Mike D.
One set of model late model springs, please. Thanks, Mark.
These are the hinge bolts at $3 when you buy the springs. Thought I would add them in as you already have the spring off.
Attached thumbnail(s)
I'm in for one early set
Most of my cars have had the springs reset at the third (farthest) slot to cure a sagging front hood.
So, will the new late springs allow placing the spring closer to the pivot?
Or would the new short springs work better to eliminate sag.
Paul
The "early' shorter springs would jive you the additional tension you are looking for. They will have a higher preload.
These will be done from finishing this Friday!
I'd like 2 sets please, one early and one late.
PMs going out tonight this will close the 20th.
Set for a 1970 and the bolts please.
PM sent to all so far !
Will close this out the 20th
I will take a set for a 76 with bolts.
I’ll take 2 sets of early with bolts
I'll take a set for a 76, plus a set of the hinge bolts, please.
I received one of the first sets from this GB and was able to get a set installed on a '75. Overall the final finish is better than original IMO. Tension was where it needed be and lifts the hood just fine. It's another nice reproduction from 914Rubber!
Old vs New
New
Old
Mark, can you put me down for 1 early set please with bolts.
Thank you,
Nick
Order submitted with 2 bolts.....
I'll have a set with bolts! - for a 74
@http://www.914world.com/bbs2/index.php?showuser=3348
I'm in for a late set of springs. PM or email me a PayPal Invoice.
Thanks.
I would like 1 set of the early ones.
Thanks
I’ll take a set for our 73, thanks Mark
One early set with bolts please.
Im in for a Late set with bolts.Thanks Mark!
I will take a set with bolts for a 73 Thanks Rods914
PM's sent to all so far. This GB closes in less than 24hrs.
One early set with bolts please.
Sorry I missed you. You got one now.
-Mark
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)