Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ 914Rubber Manual Throttle
Posted by: jim_hoyland May 16 2021, 09:07 PM
How does the guide-bracket mount ? There’s a hole for the screw and a “nub” facing upward. Is a hole needed to accommodate that nub on the bracket ?
I assume the nub is to prevent the bracket from misaligning the rod…
I’m missing that bracket 
@http://www.914world.com/bbs2/index.php?showuser=3348
Posted by: rgalla9146 May 17 2021, 04:12 AM
QUOTE(jim_hoyland @ May 16 2021, 11:07 PM) 
How does the guide-bracket mount ? There’s a hole for the screw and a “nub” facing upward. Is a hole needed to accommodate that nub on the bracket ?
I assume the nub is to prevent the bracket from misaligning the rod…
I’m missing that bracket
@http://www.914world.com/bbs2/index.php?showuser=3348
I'm pretty sure every chassis has the hole /slot that the small bracket/hanger
attaches to....on the top surface of the tunnel near the gas pedal
Attached thumbnail(s)
Posted by: mb911 May 17 2021, 05:37 AM
They do. I put one on. Please note the rubber snubber at the end falls off easily. I need to find a replacement. Probably should be glued on
Posted by: Mikey914 May 17 2021, 05:39 AM
You are correct there is a hactory hole in the chassis.
Posted by: jim_hoyland May 17 2021, 08:07 AM
Thanks for the pic; the problem has been resolved…..
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)