Just received my order from 914Rubber and the axle boots look small as compared to the single I kept when I dis-assembled them. I took the new one and measured the large side that slips over the CV flange and it is 1 3/4" and the old one measures 2 1/4". I know rubber stretches but before I destroy one getting it over the flange, I thought I would put the question out to the community. Is there more than one size boot? My car is a 70 914-6 and to the best of my knowledge, the axles are stock 25 spline and the CVs are original. Here is the part number...
Anybody successfully used these new boots? Tried to force the larger end over the CV flange and it doesn't want to happen. Smaller axle end is also going to be a stretch...literally.
The last ones I used had the flange mounted to them. Have you tried putting them in boiling water to soften them up? Just make sure the water dried off before put on the CV joint.
@http://www.914world.com/bbs2/index.php?showuser=7170
Edit.
I dont think you can strech them that much.
They should not be that hard to install.
Sounds like the boots are make wrong.
Contact 914 Rubber and see if they have had other complaints.
Pelican has them in stock. I need to order a few.
'
The short version is there are two different boots. There is one boot that goes over a smaller metal ring and is clamped on. The other version is the one that goes inside the pressed together inner and outer ring.
You can stretch the smaller boot on, its not easy, it does work and has been an issue for years in the 911 world. Why there isn't a larger boot that works is anybodys guess.
We are buying and reselling them as we can’t make them for what they go for.
Sounds like we should make the larger version that goes under a metal ring.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)