Printable Version of Topic

Posted by: motorvated Jul 4 2021, 11:39 AM

After removing the oil filter and Accusump adapter plate on my 2.0 liter four,, I found the three components of the oil filter bypass that had fallen out of the oil filter flange.


My question is how do I secure the retaining ring into the recess so that it won't come out again. Should I make a few dimples in it with a punch, lightly coat the outside of it with JB Weld, do something else, or just drive it back in and hope for the best. All recommendations welcome and appreciated.

Posted by: 914sgofast2 Jul 4 2021, 03:46 PM

I would get another oil filer housing. I wouldn't trust the one you have.
We had a similar problem with my son's 1.7L engine, but we didn't know enough about these cars yet to know where the ball and spring had come from. Son took the oil filter off but did not notice that the ball and spring had dropped into the oil drain pan. Car ran OK for a week before the motor seized due to low oil pressure at the cam bearings. When we tore it down for a rebuild, we learned where the ball and spring came from. Never did find the "locking" ring that was supposed to keep the ball and spring in the oil filter housing. Live and learn.

Posted by: bdstone914 Jul 4 2021, 06:04 PM

@http://www.914world.com/bbs2/index.php?showuser=15519
Not worth chancing a motor over if it falls out.
I have a bunch of cleaned ones.
$20 shipped.

Posted by: motorvated Jul 4 2021, 08:35 PM

QUOTE(bdstone914 @ Jul 4 2021, 06:04 PM)