Has anyone installed a Pertronix HP 510 box with a Mallory Unilite distributor on a 2056 using Ljet fuel injection? What wire did you use in the engine bay to connect the red wire from the HP 510 box that supposed to go to the ignition switch? Mechanical I can figure out, but electrical is like looking at a bowl of spaghetti!
I just installed one on my -6 conversion. Hook the thin red wire to the ignition switched 12v+ wire that went to the coil 12v+.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)