Posted by: 914werke Aug 6 2021, 12:14 PM
Are the nylock style nuts with the red seals used on the case through bolts still available new?
Posted by: Mark Henry Aug 6 2021, 01:48 PM
I think they were only a T1 thing.
Posted by: dirk2056 Aug 6 2021, 02:09 PM
QUOTE(Mark Henry @ Aug 6 2021, 01:48 PM)
I think they were only a T1 thing.
Try https://www.belmetric.com/ I was able to get about everything from them
Posted by: 914werke Aug 6 2021, 04:19 PM
QUOTE(Mark Henry @ Aug 6 2021, 12:48 PM)
I think they were only a T1 thing.
Dont think so Ive broken down many a T4 case & found them installed. Could have been from rebuilding but sure looked like they were OE
Posted by: pfreiburger Aug 6 2021, 06:15 PM
QUOTE(dirk2056 @ Aug 6 2021, 03:09 PM)
QUOTE(Mark Henry @ Aug 6 2021, 01:48 PM)
I think they were only a T1 thing.
Try https://www.belmetric.com/ I was able to get about everything from them
Agreed, I use Belmetric all the time. They have a nice selection of related hardware also.
Posted by: bdstone914 Aug 6 2021, 09:31 PM
QUOTE(914werke @ Aug 6 2021, 03:19 PM)
QUOTE(Mark Henry @ Aug 6 2021, 12:48 PM)
I think they were only a T1 thing.
Dont think so Ive broken down many a T4 case & found them installed. Could have been from rebuilding but sure looked like they were OE
Al the type IV engine I have split had them. Porsche shows them to still be available as part number 021.101.131 E, size M10 x 1.25. Cost $3.94 each. Who know what you will get.
I did not find them in Belmetric in a grade 10.
I did find these on Mcmaster-Carr
I think the originals were a taller nut.
Attached thumbnail(s)