Posted by: Speedo Aug 28 2021, 03:11 PM
Here...
Attached thumbnail(s)
Posted by: bdstone914 Aug 28 2021, 03:14 PM
The one with two holes is the backing plate for the engine lid latch.
I dont recognize the other.
Posted by: DucRS Aug 28 2021, 03:22 PM
The single holed one is for the battery hold down, I think
Posted by: rjames Aug 28 2021, 03:51 PM
QUOTE(DucRS @ Aug 28 2021, 02:22 PM)
The single holed one is for the battery hold down, I think
Posted by: bdstone914 Aug 28 2021, 05:36 PM
QUOTE(rjames @ Aug 28 2021, 02:51 PM)
QUOTE(DucRS @ Aug 28 2021, 02:22 PM)
The single holed one is for the battery hold down, I think
Nope.
It is the hold down for the headlight linkage brushes on early cars.
Attached thumbnail(s)
Posted by: SirAndy Aug 28 2021, 05:54 PM
QUOTE(bdstone914 @ Aug 28 2021, 04:36 PM)
Nope.
It is the hold down for the headlight linkage brushes on early cars.
The battery holddown is *much* larger, this is a small piece and goes onto the headlight brushes.
Posted by: Speedo Sep 4 2021, 11:46 AM
QUOTE(SirAndy @ Aug 28 2021, 03:54 PM)
QUOTE(bdstone914 @ Aug 28 2021, 04:36 PM)
Nope.
It is the hold down for the headlight linkage brushes on early cars.
The battery holddown is *much* larger, this is a small piece and goes onto the headlight brushes.
My headlight brushes are already mounted...how are these brackets supposed to mount?
Posted by: dr914@autoatlanta.com Sep 4 2021, 12:13 PM
you know your stuff, Brad was going to tell them but you beat me to the punch
QUOTE(bdstone914 @ Aug 28 2021, 04:36 PM)
QUOTE(rjames @ Aug 28 2021, 02:51 PM)
QUOTE(DucRS @ Aug 28 2021, 02:22 PM)
The single holed one is for the battery hold down, I think
Nope.
It is the hold down for the headlight linkage brushes on early cars.
Posted by: Mikey914 Sep 4 2021, 05:28 PM
It's actually the holder for the rubber flap. Screws to the body. Keep water from getting past the brushes, at least I think that was the intent.