I'm going to look at a 924 project at the Kingman pic-a-part within a few days/weeks and was wondering if there are any knowledgeable 924 folks around that would be willing to take a look at it with me. Thank you!
There is a 924 in the PaP in Vegas/Henderson if you make it up this far.
https://nvpap.com/Home/Inventory
I just know the parts that fit 914s.
I recently was looking at a 914 about 7 hours from home. I also requested the service of a fellow enthusiast in the area. I ended up sweetening the pot with $100. and it did the trick. I bought the car and have been having a ball for the past month. Too bad last weekend a CV joint failed, now I am removing the engine and chasing oil leaks and ....
Good luck with the purchase.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)