Printable Version of Topic
Click here to view this topic in its original format
914World.com _ 914World Garage _ Install racing shifter bushing without screws?
Posted by: JoeSh Oct 22 2021, 04:41 PM
My firewall shifter bushing came apart in several pieces so I'm getting a new one. Going for the racing one that's Delrin but wondering about the screws. Is there a way to put them in that won't invite rust? Or perhaps I should just epoxy it in? Love to hear your thoughts!
Joe
Posted by: bdstone914 Oct 22 2021, 06:50 PM
QUOTE(JoeSh @ Oct 22 2021, 03:41 PM) 
My firewall shifter bushing came apart in several pieces so I'm getting a new one. Going for the racing one that's Delrin but wondering about the screws. Is there a way to put them in that won't invite rust? Or perhaps I should just epoxy it in? Love to hear your thoughts!
Joe
Are using the firewall bushing make by Rix products? You could epoxy it in but hope you never have to remove it. You could probably make it stick with silicone rubber. I installed one and used pop rivets.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)