Printable Version of Topic

Posted by: Mikey914 Nov 2 2021, 11:51 AM

This one is a little special to me. It's the last part Cary asked me to make.


Attached thumbnail(s)

Posted by: mepstein Nov 2 2021, 11:56 AM

Is your rubber piece too short?

Posted by: Mikey914 Nov 2 2021, 12:01 PM

Actually, this is a piece we didn't make but is being sold as a clutch stop. We had purchased them to resell. But they aren't right for the clutch stop.

Posted by: SirAndy Nov 2 2021, 12:04 PM

Use two and sell it as: "too long, needs trimming"

Posted by: Mikey914 Nov 2 2021, 12:14 PM

Much better


Attached thumbnail(s)

Posted by: Mikey914 Nov 2 2021, 12:21 PM

We plan to do a GB for these at $3 for both pierces.

Just thought Id post this up as I promised Cary Id make these. So its not just the part, but my way of getting some closure. It bothered me seeing the sample sitting on my desk

Posted by: 914Sixer Nov 2 2021, 01:20 PM

The part is for the pedal assembly brake stop.

Posted by: bdstone914 Nov 2 2021, 03:21 PM

It is the brake and clutch pedal stop for the pedal set. It is a different profile abd does not fit the pedal board stop unkess you grind down the back side.

Posted by: Mikey914 Nov 2 2021, 04:38 PM

We’ve made an extrusion that an do both

Posted by: bdstone914 Nov 2 2021, 05:00 PM

@http://www.914world.com/bbs2/index.php?showuser=3348
What will be the price for the brake pedal stop? The aftermarket ones are $2.50 from Pelican. I use a lot of them.

Posted by: Mikey914 Nov 3 2021, 02:00 PM

The GB will be $3 for both. As far as hooking you up with a bulk price I can save you money on that. Mark