Printable Version of Topic

Posted by: Dunc Apr 18 2022, 11:34 AM

I tried searching for this item on the site, but did not find anything specific enough.

I want to remove the rear axles and replace them with some high performance axles/CVs. The Haynes and the Porsche Factory Manual indicate that removal includes driving the axle out of the swing arm. Must that be done in order to replace just the axles/CVs? It seems that merely removing the bolts at both inboard and outboard flanges should do the job. What am I missing?

Posted by: Shivers Apr 18 2022, 11:38 AM

No. There are bolts like what you see on the cv by the trans, on the outer cv.

Posted by: Optimusglen Apr 18 2022, 06:52 PM

Right, there are bolts on the outer end identical to the inner end.

One thing to take note of, the lock washers are one-time use. It's important to source new lock washers for all CV bolts, make sure the surfaces are clean and dry when reassembling, and torque to spec.

Posted by: 914werke Apr 18 2022, 07:03 PM

Thats the hard way.
Its easier to remove the .5 shaft complete.

Posted by: Dunc Apr 19 2022, 10:51 AM

Thanks you guys. I appreciate the help. Maybe take a shot at removal this weekend.

Dunc

Posted by: mgphoto Apr 19 2022, 02:16 PM

This is much easier, remove the castle nut, very difficult to remove the cv from stub axle on the wheel side while in the car.

Posted by: bdstone914 Apr 19 2022, 03:55 PM

You may need to lower the control arm on the drivers to clear the starter. Remove the top nut on the shock to drop the trailing arm as needed.

Posted by: Van B Apr 19 2022, 04:27 PM

What on earth are high performance axles for a 914? Are they painted red or something??

Posted by: Dunc Apr 20 2022, 10:29 AM

Ha. I hear ya! The car is Renegade conversion to a sb chev engine. It is my understanding that the CV's are the weak point in the drive train. So this is the mod I am making now until I update the entire drive train sometime in the future.

Posted by: Dunc Apr 20 2022, 10:43 AM

Ha. I hear ya! The car is Renegade conversion to a sb chev engine. It is my understanding that the CV's are the weak point in the drive train. So this is the mod I am making now until I update the entire drive train sometime in the future.

Posted by: Van B Apr 20 2022, 11:48 AM

Ah, yeah I get it now lol!