Hi all,
Does anybody know what this "pocket" in the right rear of the front trunk lid is/was for? Also, are there any tips or tricks I should know about putting a stainless sleeve on the worn part of the shifter rod? I presume that it's a machine shop job and has to be shrunk on? Thanks for both.
The theory I've heard is the inner structure was designed when there was going to be a fuel door in the hood and the "pocket" was to accommodate that. The fuel door was later axed in the design phase but the feature in the inner structure remained.
My hypothesis on the shift rod sleeve is... you would cut off the end after indexing its location for reattachment. Remove it. Press on a sleeve you believe is the right dimension. Weld on the end you cut off.
That being said, it looks like the powder coat layer is worn off.. maybe just have it re-powder coated to bring it back into spec? A micrometer would tell you...
@http://www.914world.com/bbs2/index.php?showuser=10844 :
My shift rod looks the same. Powder coating worn off and maybe some metal, too.
I wouldn´t worry too much, unless it is really out of round.
Get someone with a lathe to machine a new Nylon bushing that fits snug. Job done. Some clearance seems to be necessary anyways.
I replaced all bushings on my tailshifter with good-fit selfmade ones. Huge difference in shifting! No need to convert to side shifter.
The bushing in the rear firewall is somewhat a pita to get in (cut grooves like a crown to be able to press it in). Well worth the effort.
yup and yup
Many thanks to all for responding, and following on from the shifter rod topic, what is the consensus on the aftermarket bronze bushing replacements - like George sells - for the the OEM plastic thingies. Don't they contribute more wear to the shaft?
Or just buy the bushing with the groves in it. My 72 shifts well and in my opinion gets a bad rap because many folks don’t replace the bushings. Do them all, and they will make a huge difference. The factory knew what they were doing.
https://914rubber.com/tail-shift-rod-bushing-in-tunnel-for-914
Attached thumbnail(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)