I'm rebuilding a manifold pressure sensor. Unfortunately, I chewed up the threads on the MPS while removing the epoxy and backing out the stop screw.
I need to pick up a tap to clean the threads. Does anyone know what size & pitch these threads are?
Thank you.
I went out to the garage to check for you but only have a partial answer:
It is size 16, and I THINK the pitch is 1.5. But I'm not willing to bet my life on that.
I don't have the bolt gauge for that size, and I don't have a tap that's 1.0 pitch for that size, so that's the best I can do.
@http://www.914world.com/bbs2/index.php?showuser=209
It’s M16x1.0
Bob, I can chase the threads for you, just for the cost of shipping.
You can use a smaller diameter tap with the same pitch to scrape the threads. Doing that saves one from buying an expensive tap with no other use.
Thank you for the responses and for your kind offer Chris.
I found a cheap M16 X 1.0 tap & die on ebay and bought it in case I run into this problem again.
Here is the link if anyone is interested:
https://www.ebay.com/itm/155000606646?chn=ps&_trkparms=ispr%3D1&amdata=enc%3A1kS88wrQtQ-GWVxVFIpshcQ35&norover=1&mkevt=1&mkrid=711-117182-37290-0&mkcid=2&itemid=155000606646&targetid=&device=c&mktype=pla&googleloc=9006593&poi=&campaignid=17597089569&mkgroupid=&rlsatarget=&abcId=9300988&merchantid=6296724& amp;gclid=CjwKCAjwsfuYBhAZEiwA5a6CDHHppJtVOyobvwm4WgtTbAX2jSvPHotA4b2UDgxxXNp4OB
kOchfAaxoCDYMQAvD_BwE
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)