If all goes well, Mark D (McMark) will be heading on over to give me hand tuning and understanding the Link programmable fuel injection....
Andy S (sirandy) will also me swinging on over to have me modify his axles.....
Hopefully it'll be a productive day and not too much BS'ing goes on, hahaha
Mike, Link is easy...as always call me if you need a hand
QUOTE (TimT @ Aug 6 2005, 06:33 PM) |
Mike, Link is easy...as always call me if you need a hand |
I'd love to come over, but I'll be finishing up the install of my new engine tomorrow. Perhaps if you guys keep dragging into the afternoon, I can drive it over.
Mike before you even move your car out of the driveway, just tune the system at 500 rpm intervals, no load..
then you have a base to work from
dont focus one one load rpm range, take note of where the engine is working and adjust a few cells above and below the active cell... hard to describe, its easy to show you how to do
QUOTE (lapuwali @ Aug 6 2005, 06:41 PM) |
I'd love to come over, but I'll be finishing up the install of my new engine tomorrow. Perhaps if you guys keep dragging into the afternoon, I can drive it over. |
Wana wait a week and we'll tune it and my car (with Holley Pro ject, closed loop capable.. hehe) lol
What time you guys gona be rockin? I kinda want to work on the fenders and my FI a little more... buuttt... I could use some help with my axles as well
You wana borrow the LM1 unit for a week if I come over?
QUOTE (Andyrew @ Aug 7 2005, 01:19 AM) |
Wana wait a week and we'll tune it and my car (with Holley Pro ject, closed loop capable.. hehe) lol What time you guys gona be rockin? I kinda want to work on the fenders and my FI a little more... buuttt... I could use some help with my axles as well You wana borrow the LM1 unit for a week if I come over? |
ahh
Ok then, Have fun!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)