Some advice on exactly where the mounts go in a late car, and a vendor for the mounts would be great.
Pics please of the mounts welded in!
Thanks
https://914ltd.com/product/porsche-914-original-style-rear-sway-bar-mounts/
Brad Mayer makes a high quality product. These are not a thin gauge metal
We stock his stuff too. Unfortunately, will not be around my car until tomorrow evening.
Attached image(s)
Arent those are the early bar ones Mark ?
I’m looking for pictures of a late car with the bars installed.
Yes that is early not 75-76. Just pop the body plugs and weld them in.
I'll check my 75. Thought Carry used these on mine.
Will do tomorrow.
-Mark
https://914rubber.com/914ltd-late-rear-sway-bar-mount-bracket-set
Thanks for posting that up. The picture is wrong I'll get that corrected. It should be exactly the same as Brad has pictured.
Before you change anything Mark, the comments or corrections are correct.
The early brackets (70-74) are the ones you posted above.
Due to the change in the chassis to accommodate the bumper shock setup on the late 75-76 cars those brackets changed to the simpler version (on your page sixnotfour posted).
The installation is the same for both. The leading weld nut is located into the factory hole (may have a plastic cap/plug inserted) and is oriented length-wise to the back of the car & welded.
Interesting, I'm about to fab/weld in a new set of tabs into my trunk for my factory sway bar. Anyone have any info on the thickness? 16 gauge?
Here are the ones I made for my 75. Not complicated = make your own.
Just be sure to weld the 1/8" plate to the trunk floor.
Or come back later to weld up the tears in the trunk floor.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)