What is the American size open-ended wrench that I need to tighten the tie rod with?
BTW, I searched this site and couldn't find the answer.
Thanks Rob
Big Knipex pliers .................................. Channel locs will work if you don't have the good ones. The Cap'n
If you're talking about the turbo tie rods, they are 32mm which converts to 1.26".
Thanks guys, I'll get the 1 1/4" open wrench and then grind it down.
If that doesn't work, then the big old channel locks....
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)