Printable Version of Topic

Click here to view this topic in its original format

914World.com _ 914World Garage _ Door Panel Dimensions

Posted by: mmascari Jan 24 2023, 09:11 PM

I picked up some door panels and need to cut holes for the door handle. Does anyone have dimensions from bottom/top and from the front of the panel to cut? Thank you

Posted by: Mikey914 Jan 24 2023, 10:25 PM

Should be able to flip over old panels and use as a template.

Posted by: mmascari Jan 24 2023, 10:59 PM

I was able to figure it out. I didn't have old panels but I just measured from the front and bottom of the door and just cut and checked until the holes were perfect.

Posted by: dr914@autoatlanta.com Jan 25 2023, 11:22 AM

early panels are smaller than the later ones: 8/69- about 8/72 were the smaller and 9/72-12/75 were the later ones

QUOTE(mmascari @ Jan 24 2023, 08:11 PM) *

I picked up some door panels and need to cut holes for the door handle. Does anyone have dimensions from bottom/top and from the front of the panel to cut? Thank you


Posted by: jaredmcginness Jan 26 2023, 06:59 AM

Here is my sketch from a few years ago for the panels I made for my early ('71) car.

Once foamed and lined they look great - but beware, I believe they were a tad off on some measurements. Unfortunately I cannot remember which.

(P.S. this is only for the bottom portion, I drilled holes for the mounting tabs of the top cushion piece) also the length of the handle slot is 4.14"

IPB Image

Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)