I am having a problem with my heater flapper controls. The flappers are in good order and move freely. We have adjusted the cables properly. But I suspect the cables in my car are not the correct heater flapper cables. I am looking for the proper cable part number for a 914-6, as I believe the 4 cylinder cables may be longer or just different.
When I push the lever all the way down to the floor, heat is still flowing into the cabin. Any suggestions or info re the correct cables?
Thanks everyone,
Michael
-6 cables are different length. I think 914Rubber shows reproduction available.
@http://www.914world.com/bbs2/index.php?showuser=3457 - Thanks Mark. I will give the 914Rubber cables a try; just ordered.
Yes. 914 rubber has them.
@http://www.914world.com/bbs2/index.php?showuser=10825 Thanks guys.
I sent Mark the measurements from my 914-6 heater cable a few years back so the 914Rubber offering should be correct. They were off the car for measuring.
Terrific. Hopefully the new cables resolve my issue.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)