Does anyone know where I might be able to get the electrical connector to connect my oil temp sensor? It has not been connected since I installed the 3.0l engine. I am not familiar with electrical connector like this. See pic below, the terminal on the sensor is round.
Attached image(s)
Should be able to use a regular female spade connector. I think that's how my temp sensor is rigged up.
I believe a standard ring terminal will work; IIRC that part on the end is threaded so you can unscrew it and put a ring terminal over the stud.
--DD
The only trick will be the boot over the terminal.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)