Hello everyone.
I'm in Socal and will try and document the restoration of this 914. To get the thread started, I'll post some pictures of where I am currently at. Your input is welcome.
https://postimg.cc/ftSnvDQK
https://postimg.cc/Jsrf2bWt
https://postimg.cc/qh3S3w2D
https://postimg.cc/SngBFJyd
https://postimg.cc/sB1tVsxr
https://postimg.cc/rdb7s3Rt
Hello everyone.
I'm in Socal and will try and document the restoration of this 914. To get the thread started, I'll post some pictures of where I am currently at. Your input is welcome.
https://postimg.cc/ftSnvDQK
https://postimg.cc/Jsrf2bWt
https://postimg.cc/qh3S3w2D
https://postimg.cc/SngBFJyd
https://postimg.cc/sB1tVsxr
https://postimg.cc/rdb7s3Rt
Was the car originally blue or yellow, or is this two cars put into one?
This will be a serious reconstruction. Continue sharing your progress. For the ones here rebuilding theirs, it is motivating seeing other's work.
You've come to the right place Let us know how we can help.
Welcome to the madness. We love build threads with lots of pictures.
This guy has some stones
Keep us posted, it will be a journey, but satisfying
Working on a friend's 914-6 (see below) and changing out the floor pan lying on the ground, I figured I would build a rotisserie. With the amount of work required and cost of steel, I think I was better off buying one
https://postimg.cc/7GpTCC7h
Here's my friend 914-6. He wants to turn it into a race car. He's waiting on more money to continue the project.
The nightmare was filler primer added to the car on top of rust, damage, etc. had to remove all of it. Car was also full of sand from sand blasting adding to rust all done by PO.
https://postimg.cc/jLPw3QnS
https://postimg.cc/94FDf68D
https://postimg.cc/ZC8nxbX9
https://postimg.cc/r0Dz1SLc
https://postimg.cc/4KLmHWqB
https://postimg.cc/G9BsG1cY
https://postimg.cc/tnVZjFrD
https://postimg.cc/6TD4h13P
https://postimg.cc/FdksdNjH
https://postimg.cc/bGBwwsS5
https://postimg.cc/3kLKtd1w
https://postimg.cc/dZ8s66NM
https://postimg.cc/GBWnfYyb
https://postimg.cc/CR6gj9MB
https://postimg.cc/mz9BZVsc
https://postimg.cc/mtBBRQ6D
https://postimg.cc/cKgNTT6D
Built this jig. Ended up spending as much in (maybe a little more) than the rotisserie.
https://postimages.org/
Not brave enough to fab these parts:
https://postimages.org/
https://postimages.org/
Not brave enough to fab these parts:
https://postimages.org/
https://postimages.org/
FWIW. The blast dust never really goes away totally.
Any one know where to get this part?
https://postimages.org/
its the clamp for the heater tube in the longs. One of the four is done.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)