Posted by: DennisV Jul 16 2023, 08:27 AM
Would these parts have been originally painted or plated? This is for a 1970 914-6.
I can't tell from their current condition. Some of our parts were painted, and should not have been. The parts photos I find online are inconsistent.
- Drive flange (aka rear axle stub)
- Plate (zinc black phosphate, black oxide, maybe zinc clear phosphate-silver)
- Accelerator cable support (80% sure this would have been zinc yellow phosphate-gold, even though ours was clearly painted)
No guessing please. Thank you.
Posted by: 914Sixer Jul 16 2023, 11:52 AM
Stub axle was RAW steel, later on they were black oxide
Control Arm plate- black oxide/yellow zinc depending on production
Throttle cable holder-yellow zinc
Posted by: DennisV Jul 16 2023, 12:11 PM
QUOTE(914Sixer @ Jul 16 2023, 10:52 AM)
Stub axle was RAW steel, later on they were black oxide
Control Arm plate- black oxide/yellow zinc depending on production
Throttle cable holder-yellow zinc
Thanks very much Mark. Would you know these as well?
- Bearing pin (zinc clear-silver, or perhaps raw steel)
- Moon plate (some of ours appear black, others silver)
Thanks again. Another batch to the platers tomorrow.
Posted by: 914Sixer Jul 16 2023, 01:25 PM
Shock bolt- black oxide
CV locking Plate-black oxide