914-6 with CIS 2.7, Pertronix instead of points and MSD 6A box for the ignition.
Went for a drive Sunday and the 914 missed a few times, noted the tach jumped to 0, or tried to anyway.
Checked connections, visually inspected what I could. Tried to drive again today, same thing. Not very often, but it'll cut out for a second, like a power loss to the coil or the MSD Box?
Or is my MSD 6A failing? Anyone experience anything like this. Would sort of figure the 6A would either work or not work.
I have always heard they work or they don't. Interesting tach went to 0. Problem with the power to the 6al maybe? Maybe the ground on the box is getting corroded?
Fired it up, died, no restart.
Power to the MSD is good, shouldn't the orange wire go live when ignition is on? This would be the wire that goes to the coil.
My buddy Fred, Pertronics,,the plastic ring split ,,same symptoms..Then would not start ,,points back in runs good..
There is an in-between. I went down this road.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)