Working on a swap kit project that will use a 914 flywheel/engine bolt pattern and was wondering if this would be usable for all VW transmissions as well? Will a 914 flywheel fit in all 12volt Type 1 bellhousings? VW Transporter?
Basically whatever a Type 4 engine would bolt to our kit would fit.
Thanks and please ask for details if I haven't been too clear.
914 motor will bolt up to any vw trans, the 4 bolt pattern is the same. Flywheel and clutch may or may not work. The 200mm flywheel will fit in any 12 volt vw bellhousing, or 6 volt with some grinding. 215mm flywheel will not fit.
You can also use the transmission from a 912E, but they are fairly rarer.
They are a 915 transmission with a special input shaft and clutch arm to mate with the 914 2.0 engine.
Thanks for the info. This clears things up.
Go to Kenedy Engineering (KEP)They know almost every engine in the world and sell the appropriate flywheel /clutch combo there is.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)