Hi,
I just got this 2.0 with dual carbs. While examining the engine bay area. I see this wire coming out of the hole in the tin that covers the head. It's not connected and just hanging there. Where does that plug in and is it a head temp wire?
I can't seem to see where that would connect to. And if it doesn't have to connect anywhere. Should I tape off the end so there is no short?
Thanks!!!!! I posted some pics.
Attached image(s)
Tuck it away. It is not used or needed with carbs.
Yes. It is an important part of the fuel injection system. D-Jet used basically the same thing for the same reason--to see when the engine was cold or when it was warmed up.
--DD
Your car being a 73 may have the very desirable (unique) CHT sensor.
And no, you don’t need it with carbs
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)