What rear pads should I use that will fit the thick top caliper retaining pin? All the pads I see that match the 914-352-923-01 P/N seem to show the small lug hole on the pads. I would like to avoid having to enlarge the top hole on the pads.
I’d call Eric at PMB. If anyone can… Link : https://pmbperformance.com/
I’d just buy the good street pads (r4s?) over stock pads even if you have to enlarge the hole
99% of the time you have to drill out rear pads to fit pin.
What do you have on the front? I would not want mine to be too different.
The 914-6 rear pads are the same size as the 914-4 front pads (early I think? instead of late).
So, you can either find 2 more small pins (1 for each side) or just turn down the ones you have in a lathe.
Back in the day I bought the PMB Aluminum copy of the 914-6 rear calipers and made
some aluminum pins (to save weight ) (All thin pins to fit the standard holes)
Mark S.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)