I have a '72 914 and took the gauges out to clean them. I marked all of the wires so that it would be easy to reconnect all the gauges when finished. I put it all back together but when I turn on the ignition, the horn honks and won't stop until I turn the ignition off. I do notice that one brown (ground?) wire is loose and not connected to anything. It's coming from the left turn signal indicator light. I've attached a couple photos. Is this the problem? If so, where should I attach it? I appreciate any help.
Attached image(s)
Did you remove the horn pad when you were working on it? Sounds like the ground terminal or wire from the horn pad is grounded out somewhere.
This may help you out..and I agree on the horn ground wire under the horn pad.
An easy check and fix.
Thanks, everyone. Problem is fixed.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)