When one has to remove the front fenders is it just a matter of popping the tack welds?
Where are all of the welds located?
Can it be expected to match a new fender up easily or is it a painstaking ordeal?
Are fenders available?
The car I just purchased has been lightly tapped in the front(or more likely lightly tapped sonmething). Because of this it has very minor damage around the turn signal. I was told that the damage could be repaired by and experienced person without bondo but I wonder if it would make more sense to just replace the fender
I've cut my fenders off and it was no easy chore. It has to be easier to repair the existing fender. But if you need to cut a section out of a good fender to repair yours, I still have mine if you need them.
Paul
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)