I've posted pictures of my setup before but here's a little more detail. The Ford 35/1 wheel fits in the opening of the rear of the fan shroud really well.
Attached image(s)
I tucked the VR sensor behind the fan shroud in front of the oil cooler
Attached image(s)
Another view from the side
Attached image(s)
I had to get the wheel machined. We took the center out of it and put a shallow rabbit to accept a steel disk
Attached image(s)
Here's the dimensions for the disk. It replaces the washer between the fan and the fan hub.
Attached image(s)
Here's the dimensions for the wheel. No more fixed curve determined by the dissy.
Dave
Attached image(s)
Very cool
Keep us posted!
You gonna make and sell these parts? Engman you listening?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)