The two exhaust hanger bolts went MIA a few weeks back.....
I want to take care of this problem while i'm still in an actual city, so what size do i need here?
both metric and ahmerikan please?
b
search, it was asked and replied to about 2 weeks ago...
going off memory here ...8mm X 20mm ought to do it....
i'll try it, but the search doesn't like me too much.....
nothing.....
Cap'n are you on?
anybody?
QUOTE (bd1308 @ Oct 6 2005, 02:56 PM) |
nothing..... Cap'n are you on? anybody? |
take one of the other ones off and take to the hardware store? if you can swing it, get new he to muffler gaskets. you going to be right there.
k
QUOTE (rhodyguy @ Oct 6 2005, 06:26 PM) |
take one of the other ones off and take to the hardware store? if you can swing it, get new he to muffler gaskets. you going to be right there. k |
"Lock washers"? THAT'S where you went wrong. NEVER use lock washers on an exhaust. They heat up, relax, and fail. The factory used plain old nuts and flat washers, and so should you. Might get some of the metal "deformed" lock nuts. They'd work OK. Bolt - flat washer -muffler- gasket - header - flat washer - nut. The Cap'n
got it......
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)