Yesterday I was trying to raise the steering box up 1/2" with a bump steer kit. I must have cross-threaded one of the bolts because I can't get it in. I didn't apply much pressure to the bolt but I don't want to do any more damage so I want to tap it out. I think the bolt is a 10x22 (ok the new one is longer) and the threads are 1.50 but I want to make sure before I start working on it again. Does anyone know for sure what the size is?
TIA,
Mike
QUOTE (mikelsr @ Oct 9 2005, 09:14 AM) |
Does anyone know for sure what the size is? |
They would be 10x1.50. There are no 10x1.25s on a 914, and only rarely is 10x1.0 found (CHT sensor threads). The Cap'n
Thanks for the reply. Now I just have to get under it again.
M
how thick is the "washer" that comes with the kit??
Rich
about 1/2".
10x1.50 tap did it. Front end is back together.
Cap'n, thanks for the info.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)