The rubber grommets on the intake runners for a weber carb converssion, found that one of mine is split down it's back side and is leaking air like none other.
I would post a picture but I figure the part is hard not to understand and yall'd be able to figure it out
They are intake manifold boots for a stock Type I VW 1600 cc dual port engine... Most VW shops have them.....
Do not buy the ones that split in half for ease of assembly- they suck.....
QUOTE (Jake Raby @ Oct 18 2005, 12:20 AM) |
They are intake manifold boots for a stock Type I VW 1600 cc dual port engine... Most VW shops have them..... Do not buy the ones that split in half for ease of assembly- they suck..... |
SINGLE CARBS SUCK! DUAL CARBS ROCK.
Then again FI rocks a little better.
There howz that?
QUOTE (Joe Ricard @ Oct 18 2005, 09:45 AM) |
SINGLE CARBS SUCK! DUAL CARBS ROCK. Then again FI rocks a little better. There howz that? |
He's learning.... Being an asshole takes a lot of effort and its hard to get right..
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)