Could someone post a photo. I have forgotten which screw to losen to get to the main jets.
I have the Weber book but the picture doesn't show it explicitly enough to remind me.
Go here;
http://www.914world.com/bbs2/index.php?act=ST&f=2&t=40075
Go to the carb side picture .. the top flat blade brass screw is idle jets. straight down(bottom of float boal is the 10mm hex of the main jet holder . take these out main jet on the end.
3 on each side of carb. The other 10mm drains the float bowl.
Carefull when tightening , sometimes the jet holder breaks off at the holes.
Carefull when removing it drains the Gas out of the float bowl.
Cool, thanks!!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)