Does any one know where I can ge a rebuild kit for my Webers.
Thanks
Mark
call glenn sager at pelican....
is it the same as an IDA/IDS/IDC carb?
Thanks AAron
I'll call him on Monday
Mark
http://www.pmocarb.com/ad.htm
Thanks Dave
I'll send them a fax
Mark
I also use pierce manifolds. They're in Gilroy I believe and usually have all the stuff we need in stock and ship out ups.
http://www.piercemanifolds.com/
I have used Pierce Manifolds for years and they are great. They take the time to talk to you on the phone when you need parts and advice. When I had the Webers rebuilt for my stroker four they called and said the cases were shot and could not get a good shaft seal. I bought a new set from them and the old ones came back like new so I sold them to a drag racer who did not care about air leaks and got 60% of the cost of new ones back!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)