I want to install an auxillary fuse strip on the passenger side. Was looking at this web page
http://www.rallylights.com/hella/Relay_Boxes_and_Fuse_Boxes.asp
My question is which type would be most appropriate: Fuse Bloclk-HL62936 or Fuse Box-HL62935 ?
And, is there another option that I shold consider ?
Hi
This is how I did it...
http://www.914world.com/bbs2/index.php?act=ST&f=2&t=27893&hl=
Later
You bring power stright from battery ?
Hi Jim
Bad habbit of mine - post and run
Yup, I ran a good guage power wire from the battery, maxi fuses
I used a small 3 fuse Maxi fuse holder, that I took off another car, and mounted it to the battery tray, this insures no fires....
also the relay board (inside) that I used has a sepparate fuse just for the relay.
I did this because I had about 20 different car harnesses laying around, picking parts were easy, and I never seen a jobber fuse box up close, so I can't say if they are good or not.
Good luck with it
+Karma
Later
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)