I have been looking at a couple of 2.0 6's. One out of a 911 and one out of a 914. Both carbed.
What is involved in converting a 4 over to a six?
Will my tranny fit onto a a 6?
lets see...
You tranny works with a six.
The rest of your question is covered both here and at pelican parts...there are detailed how to books out there and on this site if you SEARCH you will find a detailed list with rough pricing on all the parts you need to convert a 4 cylinder to a 6.
http://www.pelicanparts.com/914/914-6_construction_kit/914-6_construction_kit.htm
Your stock 914 four cylinder transmission will work fine with a six cylinder engine.
The fifth gear for a six is lower than a four cylinder, and there's a drilled and tapped hole in the early (sixer and four tailshifters) for the 914-6 throttle linkage set up. There's plenty of conversion linkage set ups on the market though.
PM me for six conversion parts!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)