on ebay p&c's
http://www.aaproductsinc.com/cgi-bin/Porsche914_busesprice.cgi
I've never heard of them......no address, no contact person, no phone numbers. I like to know who and where internet business are located before doing any business with them.
"If" they had all that machinary I'm sure someone would have heard about them.
address and info.
AA Performance Product, Inc.
450 2nd Avenue, San Francisco, CA 94118
Tel: (415) 752-2075 Fax: (415) 752-2114
Attached image(s)
I've used them before...this company supplied P/Cs to Mark Stephens and other engine builders.
Pistons made in Japan, cylinders made in Tawain
I believe European Motorsports or Motorworks uses them as well as many other shops.
Jake does not care for them, but they do work...tend to be a tad bit louder at startup until they warm up.
Oh yea...no relationship to Automobile Atlanta
Did they use to be American Aircooled back in the 90's?
QUOTE (Mueller @ Nov 19 2005, 10:19 PM) |
Jake does not care for them, but they do work...tend to be a tad bit louder at startup until they warm up. |
thanks for the replies.
glad I did not get slammed with - use search - cause I did bt found nothing : )
prices look very good - see lower prices on ebay then on their webpage.
QUOTE (jimkelly @ Nov 20 2005, 05:17 AM) |
thanks for the replies. glad I did not get slammed with - use search - cause I did bt found nothing : ) prices look very good - see lower prices on ebay then on their webpage. |
I wouldn't run....it increases the risk of doing a faceplant in the road.
Just walk slightly faster than you usually would.
b
I'd say mueller gave them a cauiously decent rating.
still got thet 2.0 long block?
jim
There is a guy at the Shop Talk forums who is drag racing with this stuff. Do a search over there and I'm sure you'll find the info. I cant remember his name off the top of me head. (Actaully I can rememeber his name, I just cant read it off the top of me head. Anybody got a ladder and wanna help me see what I wrote up there?)
I offer them as an "ECONO" set for getting engines back on the road. I do not care for their rings at all and replace them as soon as they come into my shop.
I also magna flux all the cylinders, because I have seen them with holes right through the castings that give comopression leaks.
They are only good for patch jobs, IMHO...
i don't know, trust a guy who can't even spell the name of the city he lives in?
=========================================
Shawn Chi
shawn@itgo2u.com
415-867-2921
AA Products international
668 Dartmouth st
Sab francisco,CA,US 94134
=========================================
Jake, are the EMW cylinders that you sell a lot higher quality?
QUOTE (SirAndy @ Nov 20 2005, 03:52 PM) |
i don't know, trust a guy who can't even spell the name of the city he lives in? ========================================= Shawn Chi shawn@itgo2u.com 415-867-2921 AA Products international 668 Dartmouth st Sab francisco,CA,US 94134 ========================================= |
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)