I want to machine the braking surface on my current rotors and they measure out to 0.375 inches. What is the minimum thickness and can I have these done once more?
Are you talking front or rear?
Per the Haynes manual:
Front disks: New 0.433", Minimum 0.394"
Rear disks: New 0.0.374", Minimum 0.35"
I just replaced both front rotors on my 74 with new Zimmermans.
Old and new rotors were stamped with 8.5mm minimum (= 0.335 inches).
See if your rotors are stamped with a minimum thickness.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)