Well I'm preparing to install my Engman kit but I'm gonna clean up a few areas first. I need a little advice about the center support on the floor. Passenger side floor is rusted right below it. Is the support available anywhere? Check the pics out and advise...
Thanks!
Mike D.
Attached image(s)
No particular order...
Attached image(s)
3
Attached image(s)
4
Attached image(s)
5
Attached image(s)
6
Attached image(s)
7
Attached image(s)
8
Attached image(s)
9
Attached image(s)
10
Attached image(s)
If you look at 7 closely you can see my finger tip coming thru the hell hole.
10 is a pretty good shot of the center brace and it rot. Only on the passengers floor though...
Looks like you need to cut out some floor panels and the center brace. And probably the hell hole.
All the sheet metla is out there. Buncha different threads about doing this work. Restoration Design sells some of the metal, as does AA.
Good luck.
Zach
I've got Engmans hell hole kit and inner long kit (Thanks Mark!) and now I'm looking for that portion of the center brace and floor.. anyone got one they can sawzall out for me? My welder only has a couple of days available to me. So if anyone has a section let me know as quick as possible.
Thanks!!
Mike D.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)