Just install my getty dash. I dont think I can get that seal back on the bottom the way the dash is. In fact I had to take it off to get the dash to go in.
What does this seal do. Is it just a cosmetic thing?
Attached thumbnail(s)
QUOTE (736conver @ Jan 2 2006, 02:57 PM) |
Just install my getty dash. I dont think I can get that seal back on the bottom the way the dash is. In fact I had to take it off to get the dash to go in. What does this seal do. Is it just a cosmetic thing? |
I was thinking along those lines. I cant imagine what sealing purpose it would have.
QUOTE (736conver @ Jan 2 2006, 01:57 PM) |
I dont think I can get that seal back on the bottom the way the dash is. |
QUOTE |
mhmmm, my getty dash fit under that seal without any trouble ... |
QUOTE (736conver @ Jan 2 2006, 03:54 PM) |
Does yours go all the way to the edge like mine. |
installed ...
got enough gauges???
whats the oil tank read with a /4
and 2 temp gauges
QUOTE (Aaron Cox @ Jan 2 2006, 09:14 PM) |
got enough gauges??? whats the oil tank read with a /4 and 2 temp gauges |
very cool..... very cool....
oh i planned ahead....got a 904 gauge
Andy,
Your dash sits alot lower then mine. Mine sits flush with the lip that the seal goes on. I see by your pictures you have plenty of clearance, clarence. Thats a roger, roger.
So is this a needed seal or cosmetic.
Anyone........Bueller...........
QUOTE (736conver @ Jan 2 2006, 09:44 PM) |
So is this a needed seal or cosmetic. |
QUOTE |
So is this a needed seal or cosmetic. |
I believe it's cosmetic. But I put my Getty in without removing the windshield. Slipped right into place and I used a rubber knife to gently get the seal on top.
http://lib.nmsu.edu/~clandt/914/gettydash/index.html
You might want to put it in. I think the install will look bad without a seal there.
Cool!
I would put it on/in if it would fit. But it just doesnt. My picture above is gone now. But you can see in my new one below that my dash fits right on top of where the seal goes. I thinking the bolts that were glassed into the dash where put in the wrong spot and thats why it fits so far back.
I think my fix is painting a border on the windshield. That will still give it a nice clean look.
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)