I was replacing the O'Ring on the distributor shaft prior to installation on my new long-block when I noticed that a 'lil piece of something fell on the floor.
I picked it up. It looked like a piece of a washer or? So now I'm wondering
where it came from... I gave the distributor another spin - & sure as $hit - two more pieces fall into my hand.
WTF??? Check this out:
Attached image(s)
Sounds like the channeled washer that pulls oil up to the shaft. If that is what it is, yer lucky you found the pieces before starting the motor. I'm not sure where to get them new but I found mine easily at a place that rebuilds t4 bus motors...
check a local VW aircooled store or dune buggy store.bring it in, and they should be able to match the washer thingy for your engine.
You could feasibly remove them from a used dizzy....it doesn't have to be the one specifically for your car as there were many varations of the dizzy that used those washers.....
QUOTE (Headrage @ Jan 7 2006, 09:31 PM) |
Sounds like the channeled washer that pulls oil up to the shaft. |
OOPS, yep.
Not the metal washer.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)