Hi, I recently purchased a used dual pressure sender unit and as I prepared my parts for installation I noticed the rattle from inside. It seems like a ball bearing is loose inside. I've never handled a new sender so I don't know if this is normal or broke. TIA
I have never had one rattle, but then again, I don't recall ever shaking one to check either!
I have broke off the mounting posts with just my MIGHTY fingers...
just installed one... it doesnt rattle....
5 bar or 10 bar? which gauge are you using?
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)