So I noticed that the bolts that hold fasten the latch to the rear trunk lid were loose, so I tightened them up. Now when I hit the remote to open the trunk (I have a rear reflector and remote cilanoid (sp?) I can hear it release, but it won't open. Is there another way in this thing? (and please don't say "climb through the rust holes"
robert, were you in the silver 914, south bound I-5, midday near northgate about a month ago?
k
that was your doppelganger, Kevin......
sorry, have you tried having someone lift the trunk when you're pushing the release?
k
QUOTE (rjames @ Jan 19 2006, 04:52 PM) |
So I noticed that the bolts that hold fasten the latch to the rear trunk lid were loose, so I tightened them up. Now when I hit the remote to open the trunk (I have a rear reflector and remote cilanoid (sp?) I can hear it release, but it won't open. Is there another way in this thing? (and please don't say "climb through the rust holes" :) |
QUOTE |
robert, were you in the silver 914, south bound I-5, midday near northgate about a month ago? |
Once you get the rear trunk lid open I would recommend a piece of wire or chain attached to the release lever under the latch. Run it down through a hole in the rear trunk floor, it should be long enough and come down by the rear muffler. Adjust it so you can pull it down and it releases the trunk latch.
I had this on a 914-8 that had a remote release. this will save you if your battery is dead.
CCLINOPENSAYSME
I have the same problem with my remote trunk opener. I installed a toggle switch instead of using a momentary switch. This holds the solonoid engaged while I go to the back and press down on the trunk deck. This takes the load off and the solonoid can pull the latch. I also connected this circuit to the parking brake light so I remember that the solonoid is powered. I installed the switch on the fuse plate so it is out of sight.
Mark
I also had a similar setup .... thinking proactively, I abandoned the electric solonoid and opted to go with a manual trunk release. As mentioned in an earlier post, in addition to the manual trunk release, I also installed a pull chain thru the trunk floor as a secondary backup to the trunk release.
Attached image(s)
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)