Today, after spending most of the day grinding my welds down, I got pooped.. So I went and grabed my new trani mounts and decided I'll put them in while im resting on my back. So I take off the old one's and yup, they showed the normal fatigue, and I started to put the new one's in, but the bolt pattern was too narrow with on the new mounts.. Just by a hair.. Is this bad? Is this normal? If its normal, what should I drill, the holes on the new mount, or the holes on the body..
Thanks
Andrew
Ps: I'll post some proggress tomorrow
Normal. Drill them out (holes in the body)
B
Exactly what I figured, but didnt want to do it wrong.
Thanks,
Andrew
edit..
Ooo purty trani atvar!
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)